GoPro Hero 11 F22 Error Code Fix

by

What This Error Means

F22 on a GoPro Hero 11 is basically a storage/write fault. The camera tried to record, hit a problem talking to the microSD card or file system, and bailed to avoid trashing more footage.

It’s not a publicly documented GoPro code, but in the wild it almost always shows up with bad, fake, slow, or corrupted cards, or after buggy firmware updates.

Official Fix

  • Power the camera off, pull the battery and microSD card, and leave it 30 seconds.
  • Check the card spec: only run branded U3/V30 or faster cards (64–512 GB) bought from a real retailer. If it was super cheap or no-name, assume it’s the culprit.
  • Back up any clips you care about from the card using a computer or reader.
  • Format the card inside the GoPro, not on your PC (Preferences > Reset > Format SD Card).
  • Update the camera firmware to the latest using GoPro Quik or a manual update from GoPro’s site.
  • After updating, do a full settings reset (Preferences > Reset > Reset Defaults) to clear any weird config.
  • Test record at an easy mode first (1080p/60, Standard bitrate) for a few minutes. If that’s clean, step up to your usual 4K/5.3K setting and test again.
  • If F22 still shows up with a brand‑new fast card and fresh firmware, GoPro’s own guidance is basically: stop DIY, contact GoPro Support and start a warranty/repair claim.

The Technician’s Trick

Here’s the stuff working techs do when the “official” steps don’t cut it.

  • Force a clean firmware reload: Grab the latest firmware ZIP from GoPro, format a good card on your PC, copy the UPDATE folder only, then put that card in the camera and power it up. Let it fully reflash even if it says it was already current.
  • Clean the card and slot: Blow the slot out with dry air (no liquid cleaners). Wipe the gold pads on the microSD with a barely damp isopropyl alcohol swab, let it dry, then reinsert. Oxidized contacts cause random write errors.
  • Hard reset the electronics: Battery out, card out, then hold the Mode button for 10–15 seconds. That bleeds off the stragglers and clears some weird lockups. Then battery and card back in, power on.
  • Drop the load to prove it’s the card: Turn off 10‑bit, set bitrate to Standard, turn off HyperSmooth Boost, and record at 4K/30. If F22 disappears in this “easy” mode but comes back at 5.3K/60 or 4K/120, your card can’t keep up, no matter what the label claims.
  • Use a known‑good test card: Keep one fast V30/V60 card from a top brand just for testing. If the Hero 11 throws F22 even on that, stop burning time on cards — you’re looking at an SD slot or mainboard issue and it’s GoPro or repair-shop time.

Is It Worth Fixing? (The Financial Verdict)

  • ✅ Fix: Still under warranty, F22 only shows with one dodgy card, or it clears up after a new V30 card and firmware reload.
  • ⚠️ Debatable: Out of warranty but the camera is otherwise clean and low-hours; worth it only if GoPro or a shop quotes a reasonable flat repair price.
  • ❌ Replace: F22 appears on multiple good cards, plus other issues (overheating, random shutoffs, physical damage) — don’t sink big money, put it toward a newer body.

Parts You Might Need

As an Amazon Associate we earn from qualifying purchases.

See also

Fighting other error codes around the house too? These may help on the appliance side: